zenlinux.org

Home > Cruise Control > F150 Cruise Control Not Working

F150 Cruise Control Not Working

Contents

Here's the ProblemNovember 20, 2012Will The Ford Ranger Come Back to the U.S.?September 24, 2012Ford Contour SVT - The Forgotten Performance CarJune 14, 2013Should You Use Synthetic Oil in Your F-150?March Brake switch If stoplamps function properly, chec for battery voltage at 6 way connector (amplifier) using black wier w/green stripe,or, white wire w/pink stripe or, white wire w/purple stripe. Can you tell me where I need to look to find the additional fuse? Way to test the usage of self test mode, pop the hood and watch the servo motor cable movement. http://zenlinux.org/cruise-control/2005-ford-f150-cruise-control-not-working.html

The fuse is good. Does not have a CC light in the dash.Would it be lighted switch buttons in the Steering wheel? The time now is 03:20 AM. Sponsors -- F150online - Redesign -- Next Gen F150online - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Approx 680 ohms Switch is OK, GO to A11. <640 or >720 ohms Switch not functioning, REPLACE switch.

F150 Cruise Control Not Working

A bad VSS will also prevent the speedometer from working. javawriter 56.959 visualizaciones 1:59 2005 F150 - Cruise Control Repair - Speed Control Inhibitor Switch - Duración: 1:21. It will flash the cruise once when pushing the off button. Check for physical connection of clutch and brake electrical switches at clutch and brake pedals. 4.

Voltmeter should indicate 7.8 volts indicating on circuit is engaged. Yes GO to A7. If it wasn't working it would set a speed sensor code and flash the OD light. 2005 Ford Explorer Cruise Control Not Working Make sure the throttle returns to idle and turn the key off.

Then connect an ohmmeter between dark green wire with white stripe and black wires. F250 Cruise Control Troubleshooting ran a wire into the tank and is seem... 1995 Ford E-150 - Maintenance & Repair where is the fuse located for the TV/ VCR combination on a 1994 e150 Mark No reading SERVICE Programmable Speedometer/Odometer, GO to Section 13-02A, Speedometer/Odometer. FerdinandMagellan08 19.694 visualizaciones 14:24 ford cruise control service mode - Duración: 1:23.

set/ accel The speed control light will flash as each switch is depressed. 2004 Ford Explorer Cruise Control Not Working Iniciar sesión Transcripción Estadísticas 261.887 visualizaciones 563 ¿Te gusta este vídeo? Self Test Diagnostic Procedure - Static Test a. Top RkyMtnHi Hardcore Ford Truck Fanatic Posts: 4596 Joined: Sat Aug 21, 2004 6:58 pm Truck: 1999 F-150 4X4 -5.4 Location: Denver, Colorado My Truck Mods Re: Cruise Control troubleshooting proceedure?

  • I will pick up the new parts in the AM.
  • hatch_1989 View Public Profile View Gallery Find all posts by hatch_1989 #12 09-14-2006, 10:59 AM hatch_1989 Senior User Join Date: Sep 2005 Posts: 116 Control Button Diagnosis One
  • With the key on check pin 7 (white with light blue tracer) and pin 9 (black with yellow tracer) for power.
  • of hg.
  • Accounts are penalized for Community Guidelines violations and serious or repeated violations can lead to account termination.
  • Local Car Dealers Find car dealers by make and location.
  • Disconnect switch pigtail connector from speed control harness connector and connect an ohmmeter to the two switch connector terminals. 3.
  • Here is the test procedure I need you to perform.
  • If the parking brake or switch is misadjusted, or the switch reads "on" all the time, it will prevent the cruise control system from engaging. * A faulty Vehicle Speed Sensor
  • No No power from Deactivator, GO to C1 .

F250 Cruise Control Troubleshooting

signing off Expert: Dieseljunky2 replied4 years ago. https://www.fordf150.net/forums/viewtopic.php?t=87312 Headed down the road and cruise control now works like a champion. F150 Cruise Control Not Working Thanks Ask Your Own Ford Question Customer: replied4 years ago. 2003 Ford Explorer Cruise Control Not Working Quote: 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).

Cargando... http://zenlinux.org/cruise-control/2007-silverado-cruise-control-not-working.html If cruise now works, pick up a recall kit at your dealer parts dept (around 20 bucks) and replace both the old switch and the now-blown harness.You should have battery voltage Featured Posts:Should You Use Synthetic Oil In Your F-150? Reconnect ball chain to throttle. 5. 2002 Ford Explorer Cruise Control Not Working

Self Test Diagnostic Procedure - Dynamic Test NOTE: The dynamic test occurs automatically after the static test passes. Didn't receive a code? explain pid monitor Expert: Dieseljunky2 replied4 years ago. http://zenlinux.org/cruise-control/s10-cruise-control-not-working.html Cargando...

Also the park brake must be on. Ask Your Own Ford Question Customer: replied4 years ago. Ford F150 Cruise Control Self Test Find and remove the air bag fuse (wait at least 15 minutes before starting any work so the capacitors that store energy in the air bag system has time to dissipate A8 CHECK ON SWITCH OPERATION With ignition switch in OFF position with steering wheel ON switch depressed, measure voltage between Pin 5 (COMMAND, Circuit 151) and Pin 10 (GND, Circuit 131).

Cola de reproducción Cola __count__/__total__ #1 Reason Your Ford Cruise Control Doesn't Work Anymore FordTechMakuloco SuscribirseSuscritoCancelar111.717111 K Cargando...

Does the cruise icon light up on the dash? Ask Your Own Ford Question Customer: replied4 years ago. This must be corrected before making any other tests. 2. Turn ignition on. 2. Ford Cruise Control Deactivation Switch Quote Postby RkyMtnHi » Sat Jun 12, 2010 10:37 am Projectsho98 made this recommendation: "replace both the old switch and the now-blown harness".

Advanced Driver Assistance Systems (ADAS) Guide to the latest ADAS offerings, including Blind Spot Monitoring, Turn Assist, Backup Collision Warning and more. If they don't, you will know as you will have "Hyper Blink", as well as your Cruise control not working, as it does get power (or more accurately, the safety switch Quote Postby thudpucker » Fri Jun 11, 2010 3:16 pm UPDATE.I went to Ford this AM with the Harness they put on during the Mod in Oct 08.Today told me; "If http://zenlinux.org/cruise-control/vw-beetle-cruise-control-not-working.html If you have not done all of that, I would do so.

Remove the switch and then see if it has continuity across the terminals. Inicia sesión para que tengamos en cuenta tu opinión. Disconnect the speed sensor connector. Here are my results.

You can find it in the factory manual. All Rights Reserved × Login Please login using one of the following services: Share This Photo X Facebook Twitter Google+ Email Reddit Linkedin Pinterest X Login Please select an option before Cruise stopped working this last year and we are trying to figure out how to fix it. Aftermarket Products Air Intakes, Air Filters & Ram Air Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics Ford In-Vehicle Tech

There is no way to rebuild the unit, so it will have to be replaced if defective. * Faulty throttle actuator on a vehicle with electronic throttle control. checked all the fuse and they are fine. This speed will be maintained until a new speed has been set, brake pedal has been depressed, or the system is turned off. Clear × Alerts Signed in as |Sign Out Thanks!