zenlinux.org

Home > Door Lock > 2009 Silverado Door Lock Problems

2009 Silverado Door Lock Problems

Contents

I called the Chevy complaint line and was told that since there is no recall nothing could be done. When the car is on or when the key is in and I open the driver's side door, it will make the unlock sound (3x) but will not actually unlock. I have, in the past, gone to dealerships for a diagnosis and then fixed the problem myself. The complaints are organized into groups with data published by vehicle, vehicle component, and specific problem. Source

When a sensor...Verified for the Chevrolet 1500 Pickup73 reports sms Created with Sketch. It won't lock, but I don't have to crawl over seats to get it open. I hope you have a solution for me. It's also the case that each time he actuates the system, there is sound in the other lock solenoids, but it gets weaker with each actuation.

2009 Silverado Door Lock Problems

Ask your Chevrolet dealer. « back to accessories - interior Complaints 405 Crash Tests 13 Silverado Recalls 2 TSBs 193 Lemon Law 7.5 pretty bad Typical Repair Cost: $508.00 Average Mileage: DOOR LOCK RELAY in left fuse box. i.e. you apparently do not have the meter set on the proper voltage since you are getting OL (Over voltage).

Was this answer helpful?YesNo-2 Monday, October 26th, 2009 AT 9:46 PM Docfixit Expert 18,993 posts In same fuse box switch out lock relay with unlock if it locks then relay faulty Whenever you drive in your car, you are safer thanks in part to a lot of work over the years by this small but very effective consumer advocacy group. Thanks in advance 5 | Reply - Share Hide Replies ∧Libbie1 year 5 months agoI have the same problem of my driver door not unlocking when its hot outside. 2009 Chevy Silverado Door Lock Actuator Recall Then when he's found it, I will fix it. 1991 C2500 Silverado - Retired and back up workhorse Daly's 91 C2500 build2016 F150 RCLB - XLT 5.0 4x4 Work truck/DD...1969 D***e

I metered the fuse slot and see the top terminal is hot (12v) and the lower peg is a hard ground. could it be a bad switch? 0 | Reply - Share Hide Replies ∧Carl2 years 3 months agoHi, my passenger door locks/unlocks both doors but my driver side door works independently Where do I buy a new actuator? http://www.silveradosierra.com/interior/door-lock-not-working-t44241.html It has 80k on it and the front passenger just failed.

We just paid a Chevy dealer $700 for a tuneup, and he said it would cost another $1000 to fix our door locks! 2009 Silverado Door Lock Actuator Didn't take very long. - Dan L., Virginia, MN, USA Send Comment Add Complaint problem #23 Nov 212013 Silverado LT 5.3L V8 Automatic transmission75,000 miles Driver side door will only work I mean it can lock, but you have to manually push it down and it locks. A volt meter, available at any auto parts store, can be used to check the voltage to the individual lock solenoids and switches.

2008 Chevy Silverado Door Lock Actuator Problems

How would I report it to GM and would they care? 0 | Reply - Share Hide Replies ∧Cammi2 years 8 months agoI have a 2005 Dodge Grand Caravan. Kenk714 Firing on 3 cylinders [L1]Posts: 36Topics: 5Images: 4Joined: Feb 21 2013, 9:33pmYears of membership: Location: Baton Rouge, Louisiana Year: 2008 Make/Model: GMC Sierra Extra Info: All Terrain 5.3 Group Membership: 2009 Silverado Door Lock Problems HiI can help you but I need to know what size engine you have 4.8L,5.3L and is this a heavy duty? 1999 Silverado Door Lock Problem Today when I drive to my destination I discovered none of my door locks would lock.

Search for something else: Jump to content Sign In Create Account Search Advanced Search section: This topic Forums Members Help Files Gallery Calendar Pages Store View New Content GM-Trucks.com this contact form I hope you can give more tips! Do you think something as went bad in that module? 0 | Reply - Share Hide Replies ∧Lauren2 years 2 months agoI have a 2003 Nissan Micra 3dr (new shape) - Yesterday and today the VSC light came 11/11/2016 11/11/2016 baddad1 2003 Chevy Silverado 1500 5.3L. 1998 Chevy Silverado Door Lock Malfunction

Fix It Like a Pro Headlight Bulb Replacement GMC Yukon Headlight Bulb Out? I you have 12 volts and a ground then the solenoid is defective. 0 | Reply - Share Hide Replies ∧Rich2 years 4 months agoCarl - Love your insight! Armstrong2 years 8 days agoIam out of town. http://zenlinux.org/door-lock/dodge-grand-caravan-door-lock-problems.html It is NOT a heavy duty Expert: Eric replied5 years ago.

The actuator should be vertical to the door. Gmc Sierra Door Lock Actuator Recall Can you tell me what my next step should be? 1 | Reply - Share Hide Replies ∧Danny Gonzales2 years 25 days agoHi, I have a 2004 honda accord. However, I had the dealer take care of mine in the summer of 2009 and it was all covered under warranty.

If it is bad, where can I obtain another one....Chevy dealer only?

It will unlock with the key, just not with the key fob or electric button on the inside. I have read that this is a common problem on 2008 Silverado's and that the problem is a faulty actuator. Do you know what the issue is? 0 | Reply - Share Hide Replies ∧ian2 years 5 months agoMy alarm goes off in my car no matter what i do. 1998 Gmc Sierra Door Lock Problems I've had several fleet F250s with power locks and you can tell they are going out as they start to get weak.

It is labeled "cig liter" but the cigarette lighter works even when this fuse is unplugged. Geri al Kapat Bu video kullanılamıyor. İzleme SırasıSıraİzleme SırasıSıra Tümünü kaldırBağlantıyı kes Yükleniyor... İzleme Sırası Sıra __count__/__total__ How to fix the Chev power window door lock switch spelunkerd Abone olAbone olunduAbonelikten Reply View Public Profile Send a private message to toms01 Find all posts by toms01 CF Addict Join Date: Apr 2012 Posts: 2,176 Miami, FL. Check This Out I continued to test the wires from the power door locks and this is what I did: 1) With the door panel out, I reconnected the switches for power doors

mdcollins50 24.267 görüntüleme 13:27 How to fix a car mirror that won't move -- Chev Suburban - Süre: 9:54. Thanks. Drivers door is starting to do the same thing as are the rear doors. A week later the rear passenger door failed as well.

Got to be bad selonoid, wire or ground. I took off the 3 bolts for the inside door skin, and the cap near the mirror, and starting at the inside lock pulled back the door skin enough to fit They failed one at a time in about a six month period. Everything else works fine, the only thing that doesn't work is when the door tries to lock.

Here´s a pic of the stripped door. Log in to comment Not a Member Yet? This was remedied in 2010 for some trucks! Operate each door lock switch in the vehicle to determine if the doors can be locked with any of the switches.

Like I said, the right combo will give a +12v reading when the switch is pushed one way, and a -12v reading the other way. What could the problem be? 0 | Reply - Share Hide Replies ∧Pat Langan2 years 1 month agoI have a 2004 Chevy Impala. Hiok you need to test for power at the passager switch, if no power at switch then check for power at the fuse box, if still no power then test for I have been a loyal Chevy owner for over 35 years.

I also drilled a small hole in the panel and used a zip tie to hold the new wiring away from the window as it slides down. A friend has a 2005 Dodge Neon. Back EXT. Thanks ahead of time. 0 | Reply - Share Hide Replies ∧Cole2 years 2 months agoHi, I have a 2006 Crown Vic P71.

The locks in my car use to go up and down by itself.I replace the drivers side switch. Forgot your Password?